ESPBell-MAX Intercom Doorbell Module

ESPBell-MAX "IoT Intercom / Doorbell" module specifically made for Home Assistant, enables you to stay informed whenever someone rings your doorbell or presses the intercom button. Upon receiving an interactive notification, you have the convenience to either promptly open the door or choose to dismiss the alert by simply tapping the button within the notification.

Documentation and code available on GitHub

Specifications

• Based on ESP12F "Programmable via pads on the PCB"
• Power consumption
• - Standby mode: 0uAh
• - When triggered: 21uAs - a few seconds
• Input / Output
• - 2 x "R1/R2" SSR 2.4A 30v Max
• - 1 x "DB" Input Optocoupler 2-30v Max "For Doorbell"
• - 1 x "ET" Input 3.3-5v Max "External Trigger"
• - 1 x "B+" Battery Voltage "Permanent output"
• - 1 x "E+" Battery Voltage "When ESPBell is enabled"
• - 1 x GPIO14
• - 2 x GND "Only! for ET/B+/E+/GPIO14"
• Status LEDs - Can be deactivated "PCB Jumper"
• - 1 x R1
• - 1 x R2
• - 1 x DoorBell
• - 1x Power
• - 1x On ESP module "Not used"
• Battery type Li-Ion 18650
• Button for flashing Firmware

What Included in the KIT

• Assembled ESPBell-MAX PCB
• Cable 30cm 12P

Requires

• Battery Li-Ion 18650 "Not included"
• Battery charger "Not included"
• 3D Printed Case "Optional"

Please note that this device requires manual configuration, compiling, and reflashing of the firmware using Arduino IDE and UART programmer. It's not a plug-and-play device. If you're not comfortable with these steps, this product might not be suitable for you.